System Requirements For Pg Routing; Preparations For Pg Routing; Setting The Pg/Pc Interface And Assignment; Properties Of The Pg/Pc Interface - Siemens SIMATIC TIM 3V-IE DNP3 System Manual

PG routing via WAN

B.2 System requirements for PG routing

B.2

System requirements for PG routing

Software requirements
To use the PG routing function in the SINAUT telecontrol network with SINAUT DNP3, the
following requirements must be met:
● STEP 7 is installed on the PG/PC.
You will find the required version in Preface (Page 3).
● The SINAUT software package is installed on your PG/PC.
You will find the required version in Preface (Page 3).
B.3

Preparations for PG routing

B.3.1

Setting the PG/PC interface and assignment

Before you perform PG routing over the SINAUT telecontrol network with your PG of PC, you
must first adapt the properties of the PG/PC interface and set the assignment of the PG/PC
in the SINAUT network.
B.3.2

Properties of the PG/PC interface

Adapting the PG/PC interface
1. Open the
2. Select the
3. In the
assignment used
4. Then click on the
5. Confirm the warning dialog with
336
Control Panel
window by clicking on the
Set PG/PC interface
Set PG/PC Interface
dialog, set the Ethernet interface in the
box.
Properties
button.
Start / Settings / Control Panel
icon.
Yes
. The properties dialog of the interface opens.
System Manual, 12/2015, C79000-G8976-C253-04
menu.
Interface parameter
TIM DNP3