Note
The protection elements in the OPM (Overvoltage Protection Module) undergo high stress
during discharge processes and progressively deteriorate. It is therefore recommended that
you replace the OPMs approximately once a year. To be on the safe side, in regions with
frequent thunderstorms this period should be reduced to approximately 6 months.
Structure of the LTOP variants
The housing contains either one LTOP unit (= LTOP 1) or two LTOP units (= LTOP 2). The
following figures show the design of both LTOP variants with their connectors and
configuration switches.
View from above
X1
X2
X2 + X3
X6
S1 + S2
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
Dedicated line (screw terminals 1, 2, 5, 6)
Chassis (screw terminals 3, 4)
Modem attachment 2-wire over screw terminals
Modem attachment 4-wire over screw terminals
Modem attachment 2-wire/4-wire via RJ-12 western plug
Configuration switches
A.5 LTOP overvoltage protection modules
Schematic
Accessories
329