Siemens SIMATIC TIM 3V-IE DNP3 System Manual page 294

Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
Event ID Detailed Status message
(hex) event
(hex)
F560 0405 DNP3 data output locked
F360 0405 DNP3 data output released
F560 0406 Unknown control message
F560 0407 Error releasing memory
F560 0408 Time-of-day function not available
F560 0409 WAN SDB cannot be interpreted
F560 040A Error creating a task
F560 040B WAN driver successfully installed.
F960 040C Modem does not set CTS signal
F860 040C Modem sets CTS signal again
F560 040D WAN interface disrupted
F460 040D WAN interface OK
F560 040E WAN driver ready for communication
F560 040F Time synchronization received
F560 0410 Unsolicited event transmission activated
or deactivated
F560 0411 IP connection established
F360 0411 IP connection terminated
F560 0412 Inconsistent routing table
F360 0413 DNP3 connection disrupted
F260 0413 DNP3 connection established
F560 0414 Size of the process image of the inputs
F560 0415 Size of the process image of the out-
puts
F560 0416 TD7 data cannot be interpreted
F560 0417 Unknown DNP3 subscriber address
received
F560 0418 Command rejected
F560 0419 Command not supported
F560 0420 Installation abort - DNP3 stack has
detected an inconsistent parameter
assignment.
294
Meaning
No DNP3 communication possible
DNP3 communication possible
Internal error
The available RAM memory on the module is exhausted.
Time-of-day synchronization by DNP3 master station not
possible
Inconsistent system data block
Internal error
DNP3 driver loaded
CTS control signal on the serial interface inactive
CTS control signal on the serial interface active
Serial communication disrupted. Bad data frame, for
example due to incorrect baud rate or invalid parity.
Serial communication is OK again.
WAN driver ready
DNP3 master station has synchronized system time.
Request to activate of deactivate unsolicited messages
Connection to DNP3 master station was established.
Connection to DNP3 master station was terminated.
Inconsistent configuration
Connection to specified master station disrupted
Connection to specified master station established
Highest DNP3 indexes of the input values (received from
DNP3 master station) are output.
Highest DNP3 indexes of the output values (sent to
DNP3 master station) are output.
Internal error
DNP3 master station sends unknown address. The re-
ceived master station and station address are displayed.
A command of the DNP3 master station could not be
executed. Object group, variation and type of the com-
mand are displayed.
An unknown or unsupported command of the DNP3
master station was received. Object group, variation and
type of the command are displayed.
Configuration error
System Manual, 12/2015, C79000-G8976-C253-04
TIM DNP3