Dnp3-Specific Diagnostics Messages Of The Tim - Siemens SIMATIC TIM 3V-IE DNP3 System Manual

The following table contains a summary of all error messages that caused the group error
LED (SF) to light up.
Table 7- 5
Error class
Internal error
External error
No parameter assignment
Bad parameter assignment
RAM error
7.3.6.3

DNP3-specific diagnostics messages of the TIM

Diagnostic messages
Below you will find a list of the DNP3-specific diagnostics messages sorted according to the
detailed event:
Event ID Detailed Status message
(hex) event
(hex)
F560 0400 No TD7onTIM configuration exists
F560 0401 Memory error
F560 0402 Error receiving message
F560 0403 Amount of diagnostics data to high
(> 32 767). Diagnostics data of the
event buffer cannot be transferred
F560 0404 Unknown ORG PDU received
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
Classification of the messages and activation of the group error LED
Detailed event (hex) in the diagnostics message
0061
0063, 0064, 0065, 0066, 0067
0069
0078, 0079, 0080
0083
06B0
0320
0070
0071
0620
0077
0081
0110
0112
0300
031C
0500
0620
0085
0086
7.3 SINAUT diagnostics and service tool
Meaning
TD7onTIM configuration data was not transferred to the
module.
The available RAM memory on the module is exhausted.
Internal error
Diagnostics data relating to message management could
not be transferred to the diagnostics tool.
Internal error
Diagnostics and upkeep
293