Siemens SIMATIC TIM 3V-IE DNP3 System Manual page 217

Default:
Explanation:
DNP3_Cmd01X_R
Channel "CmdReceive"
Channel type: Receive DNP3 command
The object is intended for the station and occupies 1 index.
As the data destination of the command, a bit variable of the S7 CPU is specified.
The channel allows receipt of a DNP3 command with the following control information:
● LATCH_ON / LATCH_OFF
● PULSE_ON
– NUL
– CLOSE
– TRIP
When the byte "Control Code" is received with the function "PULSE_ON" information sent
with it by the master "Count", "On-time" and "Off-time" is evaluated. This information is
compared with the relevant object parameters "Max.pulse duration", "Pulse duration
equivalent time" and "Number ofpulses" (see below).
The data object supports the following control codes id the object is suitably configured and
the necessary information is received from the master.
Table 6- 8
Control
Code
0x01
0x03
0x04
0x41
0x81
Note that DNP3_Cmd01X_R only has one output. If both the function "LATCH_ON/OFF" and
the function "PULSE_ON" are to be used for a switching device. separate objects need to be
created for both functions.
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
5
Time during which the command output of the channel is active. When the
configured time has elapsed, the bit is reset to zero by TD7onTIM.
Functions of the data object
Receipt of:
TCC Op Type
NUL PULSE_ON The output is set to 1 for the
duration of "On-time".
NUL LATCH_ON The command is rejected.
NUL LATCH_OFF The command is rejected.
CLOSE PULSE_ON The output is set permanently
to 1 (as with LATCH_ON).
TRIP PULSE_ON The output is set permanently
to 0 (as with LATCH_OFF).
The SINAUT Configuration Tool
Reaction of the object depends on the configuration
Output mode =
Pulse on
6.6 TD7onTIM
Output mode =
Latch on/off
The command is rejected.
The output is set permanently
to 1.
The output is set permanently
to 0.
The command is rejected.
The command is rejected.
217