Recovering Lost Connections - Siemens SIMATIC TIM 3V-IE DNP3 System Manual

The SINAUT Configuration Tool
6.4 The connection configuration
The permitted connections must keep to the following rules:
● A connection must not run through an inconsistent network. Examples are described
along with the plausibility check in the network configuration.
Note
To avoid including large numbers of connections unnecessarily in the list of possible and
configured connections, some connections used between two subscribers in both
directions are shown only in one direction.
A connection displayed in the configuration tool is always valid in both directions.
6.4.3

Recovering lost connections

If changes are made to connections in a project, it is advisable to open the
connections
● The
● The
If changes to the connection configuration, previously existing connections were modified
and either linked to other objects or completely deleted, connection configuration has
algorithms with which to find these lost connections in the project.
Deleted connections are displayed in red in the left-hand part of the
connections
listed in the right-hand part of the window. This allows you to check whether there is a
substitute or successor to the last connection.
If you no longer require the lost connections in the left-hand part of the window, you can
delete these by selecting and clicking the
If connections are displayed in the right-hand part of the window that are similar to the last
connections you can insert these again if you have accidentally deleted connections and still
require them. To do this, select the connection in the right-hand part of the window and click
the
148
window afterwards. You can do this with:
SINAUT / Recover lost connections
Recover lost connections
window. Connections that are similar to the deleted connections may also be
Recover connections
button.
menu or
button on the right of the toolbar
Delete lost connections
System Manual, 12/2015, C79000-G8976-C253-04
Recover lost
Recover lost
button.
TIM DNP3