BENSHAW RSi GX Series Hardware Manual page 46

4 - Operation
Frequency Setting
•
When changing run frequency to 30.05 Hz in Drive group.
0.00
1
0.00
2
0.05
3
0.05
4
0.05
5
00.05
6
30.05
7
30.05
8
z Note: The RSi-GX display can be extended to 5 digits using left (t)/right (u) keys.
z Note: The parameter setting is disabled when pressing other than Enter Key in step 7.
Changing parameter value in Function group
•
When changing the parameter value of F28 from 2 to 5.
F 0
1
2 1
8
3
08
4
28
5
F 28
6
2
7
5
8
F 28
9
F 0
10
z Note: The above setting is also applied to change parameter values in function group 2 and I/O
group.
40
In "0.00", press the Ent (˜) key once.
The second decimal 0 becomes active.
Press the UP (p) key until 5 is displayed.
Press the Left (t) key once.
The first decimal 0 becomes active.
Press the Left (t) key once.
Press the Left (t) key once.
Set 3 using UP (p) key.
Press the Ent (˜) key.
30.05 is blinking.
Press the Ent (˜) key.
30.05 is entered into memory.
In F0, press the Ent (˜) key once.
Check the present code number.
Increase the value to 8 by pressing the Up (p) key.
When 8 is set, press the Left (t) key once.
0 in 08 is active.
Increase the value to 2 by pressing the Up (p) key.
28 is displayed
Press the Ent (˜) key once.
The parameter number F28 is displayed.
Press the Ent (˜) key once to check the set value.
The preset value 2 is displayed.
Increase the value to 5 using UP key (p).
Press the Ent (˜) key.
Code number will appear after 5 is blinking. Parameter change is
complete. Press either Left (t) or Right (u) keys.
Moving to first code of Function group 1 is complete.