BENSHAW RSi GX Series Hardware Manual page 115

Range:
Description:
Range:
Description:
0 - 5 (Default: 0)
This parameter is used to initialize parameters back to the factory default
value. Each parameter group can be initialized separately or all parameters
can be initialized at once.
Setting Range
Selection Display
No 0
Displayed after initializing parameters.
All
1
All parameter groups are initialized to factory default value.
Groups
DRV 2
Only Drive group is initialized.
F1 3
Only Function group 1 is initialized.
F2 4
Only Function group 2 is initialized.
I/O
5 Only I/O group is initialized.
Select Enter (˜) key after setting in H93. H93 will be displayed again
•
after initialization is complete.
0 - FFFF (Default:0)
Password for H95-[Parameter lock]. Set as Hexa value (0-9, A, B, C, D, E,
F). Factory default password is 0. Enter the new password except 0.
Do not forget the registered password. It is used when unlocking the
parameters.
Move to parameter H94 code.
•
Press Enter (˜) key twice.
•
Register password. (Ex: 123).
•
Password will blink when Enter (˜) key is pressed.
•
Press Enter (˜) key.
•
6 - Parameter Descriptions
H93: Parameter Initialize
Description
H94: Password Register
CAUTION
109