Receiving And Installation; Preliminary Inspection; Installation Precautions - BENSHAW RSi GX Series Hardware Manual

3 - RECEIVING AND INSTALLATION

Preliminary Inspection

3.1 Preliminary Inspection
Before storing or installing the RSi GX Drive, thoroughly inspect the device for possible
shipping damage. Upon receipt:
Remove the drive from its package and inspect exterior for shipping damage. If damage
•
is apparent, notify the shipping agent and your sales representative.
Remove the cover and inspect the drive for any apparent damage or foreign objects.
•
Ensure that all mounting hardware and terminal connection hardware is properly seated,
securely fastened, and undamaged.
Read the technical data label affixed to the drive and ensure that the correct horsepower
•
and input voltage for the application has been purchased.
If you will store the drive after receipt, place it in its original packaging and store in a
clean, dry place free from direct sunlight or corrosive fumes, where the ambient
temperature is not less than -20°C (-4°F) or greater than +65°C (+149°F).

Installation Precautions

3.2 Installation Precautions
Improper installation of the RSi GX Microdrive will greatly reduce its life. Be sure to
observe the following precautions when selecting a mounting location. Failure to observe
these precautions may void the warranty!
Handle the drive with care to prevent damage to the plastic components. Do not hold the
•
drive by the front cover. It may fall off.
Do not mount the drive in a location where excessive vibration (5.9 m/s
•
present such as installing the drive on a press or other moving equipment.
Install in a location where temperature is within the permissible range (-10~50°C).
•
The drive will be very hot during operation. Install it on a non-combustible surface.
•
Mount the drive on a flat,
•
vertical and level surface. The
drive orientation must be
vertical (top up) for proper heat
dissipation. Also leave
sufficient clearances around the
drive.
20
Temp checking
point
Drive
5 Cm
Temp
checking point
5 Cm
A: 10cm Min
B:5cm
Min
Drive
A: 10cm Min
2
or less) is
5 Cm
Leave space enough to
allow cooled air flowing
easily between wiring
duct and the unit.
B:5cm
Min
Cooling air
Cooling fan