Configuring Igmp - SMC Networks TigerStack 100 1000BASE-X Management Manual

Configuring IGMP

This protocol allows a host to inform its local switch/router that it wants
to receive transmissions addressed to a specific multicast group. You can
use the IGMP Configuration screen to configure multicast filtering shown
below.
IGMP Status
IGMP Query Count
IGMP Report Delay (Seconds) : 10
<APPLY>
Use <TAB> or arrow keys to move. <Space> to scroll option.
Parameter
IGMP Status
IGMP Query Count
IGMP Report Delay
Note: The default values are indicated in the sample screen.
IGMP Configuration
==================
<OK>
Description
If enabled, the switch will monitor network traffic to
determine which hosts want to receive multicast traffic.
This is also referred to as IGMP Snooping.
The maximum number of queries issued for which
there has been no response before the switch takes
action to solicit reports.
The time (in seconds) between receiving an IGMP
Report for an IP multicast address on a port before the
switch sends an IGMP Query out that port and
removes the entry from its list.
C
ONFIGURING THE
: ENABLED
: 2
<CANCEL>
S
WITCH
2-49