Cli: Configuring And Displaying Igmp - SMC Networks SMC6624M Management Manual

Configuring Advanced Features
Multimedia Traffic Control with IP Multicast (IGMP)
Note that Fast-Leave operation does not distinguish between end nodes on
the same port that belong to different VLANs. Thus, for example, even if all of
the devices on port 7 in figure 9-67 belong to different VLANs, Fast-Leave does
not operate on port 7.

CLI: Configuring and Displaying IGMP

IGMP Commands Used in This Section
show ip igmp configuration
ip igmp
show ip igmp
Viewing the Current IGMP Configuration. This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax:
(For IGMP operating status, see "Internet Group Management Protocol
(IGMP) Status" on page 10-16.)
For example, suppose you have the following VLAN and IGMP configurations
on the switch:
VLAN ID VLAN Name
1
22
33
You could use the CLI to display this data as follows:
9-96
high-priority-forward
auto <[ethernet] <port-list>
blocked <[ethernet] <port-list>
forward <[ethernet] <port-list>
querier
show ip igmp config
show ip igmp <vid> config
IGMP
Enabled
DEFAULT_VLAN Yes
VLAN-2 Yes
VLAN-3 No
page 9-96
page 9-97
page 9-99
page 9-98
page 9-98
page 9-98
page 9-99
See "IP Multicast (IGMP) Status" on page 10-16
IGMP configuration for all
VLANs on the switch
IGMP configuration for a
specific VLAN on the switch,
including per-port data
Forward with Querier
High Priority
No No
Yes Yes
No No