Setting An Ip Address - SMC Networks 6724AL2 Management Manual

S M
WITCH ANAGEMENT
1. Open the console interface with the default user name and password
"admin" to access the Privileged Exec level.
2. Type "configure" and press <Enter>.
3. Type "username guest password 0 password," for the Normal Exec
level, where password is your new password. Press <Enter>.
4. Type "username admin password 0 password," for the Privileged Exec
level, where password is your new password. Press <Enter>.
User Access Verification
Username: admin
Password:
CLI session with the SMC6724AL2 is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#

Setting an IP Address

You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or
DHCP address allocation servers on the network.
Note: Only one VLAN interface can be assigned an IP address (the
default is VLAN 1). This defines the management VLAN, the only
VLAN through which you can gain management access to the
switch. If you assign an IP address to any other VLAN, the new IP
address overrides the original IP address and this becomes the new
management VLAN.
1-6