Plywood Base For A Wall With Wooden Studs - Allied Telesis x530 Series Installation Manual

Chapter 6: Installing the Switch on a Wall

Plywood Base for a Wall with Wooden Studs

78
If you are installing the switch on a wall that has wooden studs, use
plywood base for the device. (A plywood base is not required for a
concrete wall.) Refer to Figure .
Wall
Plywood Base
Switch on the Wall with a Plywood Base
Mount the plywood base to two studs in the wall. The recommended
minimum dimensions of the plywood base for the AT-x530-28GTXm or
AT-x530-28GPXm switch are:
Width: 55.9 centimeters (22 inches)

Height: 61.0 centimeters (24 inches)

Thickness: 2.5 centimeters (1 inch)

The dimensions assume the wall studs are 41 centimeters (16 inches)
apart. You might need to adjust the width of the base if the distance
between the studs in your wall is different than the industry standard.
Wall Studs
AT -x
53 0-
28 G
TX m
4592