Chapter 4
Installing the Switch on a Table
This chapter contains the instructions for installing the switch on a table or
desktop.
Warning
Switches should not be stacked on a table or desktop. They could
present a physical safety hazard if you need to move or replace
switches. E91
Warning
The switch is heavy. Always ask for assistance when moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
The switch comes with four bumper feet in the accessory kit. The feet,
which are reusable, are used when installing the switch on a table. If they
are already assembled, disassemble them by removing the rivets and rivet
housings from the bumper feet. Refer to Figure 17.
Figure 17. Parts of the Bumper Feet
The holes in the base of the switch for the bumper feet are shown in Figure
18 on page 64.
Note
Although you cannot stack the switches on top of each other, they
can be placed next to each other.
Rivet
Rivet Housing
Bumper Foot
63