Installing At-Sp10Tw Direct Connect Twinax Cables In At-X530-28Gtxm And At-X530-28Gpxm Switches - Allied Telesis x530 Series Installation Manual

Installing AT-SP10TW Direct Connect Twinax Cables in
AT-x530-28GTXm and AT-x530-28GPXm Switches
The SFP and SFP+ transceiver slots 25 to 28 on the AT-x530-28GTXm
and AT-x530-28GPXm switches support AT-SP10TW direct connect
twinax cables. The cables are an economical way to add 10 Gbps
connections over short distances. They have SFP+ transceivers on both
ends and come in lengths of 1, 3, and 7 meters.
To install AT-SP10TW cables in AT-x530-28GTXm or AT-x530-28GPXm
switches, perform the following procedure:
1. Select a slot for the transceiver.
2. If the slot has a dust cover, remove the cover. Refer to Figure 43 on
page 112.
3. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
4. To install the transceiver in a slot in the top row, position the
transceiver with the Allied Telesis label facing up. To install the
transceiver in a slot in the bottom row, position the transceiver with the
label facing down. Refer to Figure 48.
x530 Series Installation Guide for Virtual Chassis Stacking
115