Figure 8: Switch Id Led Description - Allied Telesis x530 Series Installation Manual

Chapter 1: Overview
36
The states of the LED when the switch is not operating in the low power
mode are shown in Figure 8.
The switch is booting up.
The switch has encountered a fault condition.
The switch is operating as a stand-alone unit.
The switch has an ID number of 1 to 4 as part of a
VCStack.
The dot in the lower right corner flashes when the switch
accesses USB memory.
When the eco-friendly mode is enabled, the front panel LEDs
are in OFF mode. The horizontal segments will be lit up to
show power status and mode of stacking:
Lower segment: Member
Middle segment: Standalone
Upper segment: Master
No segment illuminated: No Power
Figure 8. Switch ID LED Description
The switch displays the letter "F" for fault on the ID LED if it detects one of
the following problems:
A cooling fan has failed.

The internal temperature of the switch has exceeded the normal

operating range and the switch may shut down.
Note
You can use the SNMP or the command line management interface
to determine the type of fault or faults.