Introduction - Allied Telesis x530 Series Installation Manual

Chapter 7: Powering On the Stack

Introduction

92
This chapter contains instructions for powering on the stack for the first
time. There are two procedures:
Perform "Powering On the Switches Individually" on page 94 if you

want to control the assignment of the ID numbers to the switches
of the stack. The numbers are assigned in the order in which you
power on the units.
Perform "Powering On the Switches Simultaneously" on page 98

to have the switches assign the numbers automatically. After the
ID numbers are assigned, you may change them with the STACK
RENUMBER command, described in the Software Reference for
x530 Series Switches, AlliedWare Plus Operating System.
Caution
You should not change the ID numbers of the switches after
beginning to configure the parameter settings. Otherwise, the stack
might assign configuration settings to the wrong units.