Port Pinouts; Leds; Figure 4: At-X530-28Gtxm Twisted Pair Ports 1-24 Leds; Table 5: At-X530-28Gtxm Twisted Pair Ports 1 - 24 Led Functions - Allied Telesis x530 Series Installation Manual

Port Pinouts

Refer to Table 18 on page 126 for the port pinouts of the 100 Mbps and
1 Gbps twisted pair ports.

LEDs

Each twisted pair port has two LEDs that display the port status.
AT-x530-28GTXm
The AT-x530-28GTXm LEDs indicate Link/Activity (L/A) and Duplex/
Collision (FDX/HDX/COL) information. These LEDs are shown in Figure 4.
The states of the AT-x530-28GTXm LEDs are described in Table 5.
Table 5. AT-x530-28GTXm Twisted Pair Ports 1 - 24 LED Functions
LED
L/A
D/C
L/A LED
Figure 4. AT-x530-28GTXm Twisted Pair Ports 1-24 LEDs
Ports State
Solid Green
Flashing Green
Solid Amber
1 - 24
Flashing Amber
Off
Solid Green
Solid Amber
1 - 24
Flashing Amber
x530 Series Installation Guide for Virtual Chassis Stacking
D/C LED
7 9 11 13 15 17
8 10 12 14 16 18
Description
The port has established a 1 Gbps link to a
network device.
The port is transmitting or receiving data at
1 Gbps.
The port has established a 100 Mbps link
to a network device.
The port is transmitting or receiving data at
100 Mbps.
Possible causes of this state are:
- The port has not established a link with
another network device.
- The LEDs are turned off. To turn on the
LEDs, use the eco-friendly button.
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
The port is operating in half-duplex mode
with collisions.
25