Table of Contents
Advertisement
28 March 2018
2.
Hold the vessel holder and support frame on both hand grips
and replace it around the thermal blocks from the top.
3.
Engage the vessel retaining brackets, i.e. release the clamps
of the snap closure between the thermal blocks.
For this, hold both clamps, pressing the left-hand clamp in-
wards at the same time.
NOTICE!
Do not pull the right-hand clamp forwards!
4.
Pull the mounting plate with the pump heads out of the bottom
part of the vessel holder and support frame.
5.
Plug the mounting plate with the pump heads onto the pump
motor drive shafts on the basic unit.
Multifors 2 - Parallel Bench-top Bioreactor
Preparations for Use
Page 147 of 211
Advertisement
Table of Contents
Need help?
Do you have a question about the Multifors 2 and is the answer not in the manual?
Questions and answers