Com-Hpc Interface Connector; Connecting Com-Hpc Interface Connector To Carrier Board - Kontron COMh-caRP User Manual

4. COM-HPC Interface Connector

The COMh-caRP is a COM-HPC® Client module containing two 400-pin connectors J1 and J2; each with
4 rows called rows and all rows are named A to D on the primary connector J1 and E to H on the
secondary connector J2.
Figure 8: COM-HPC Interface Connectors
1. COM-HPC interface connector (J1)
2. COM-HPC interface connector (J2)
4.1 Connecting COM-HPC Interface Connector to Carrier
Board
The COM-HPC interface connectors (J1, J2) are inserted into the corresponding connectors on the
carrier board and secured using the mounting points and standoffs. The height of the standoffs
depends on the height of the carrier board's connector.
The module is powered on by connecting to the carrier board using the interface
connector. Before connecting the module's interface connector to the carrier board's
corresponding connector, ensure that the carrier board is switch off and disconnected
from the main power supply. Failure to disconnect the main power supply could result in
personal injury and damage to the module and/or carrier board. Observe that only
trained personnel aware of the associated dangers connect the module, within an access
controlled ESD-safe workplace.
www.kontron.com
COMh-caRP User Guide
37/60