Com-Hpc Interface Connector; Connecting Com-Hpc Interface Connector To Carrier Board - Kontron COMh-sdID User Manual

4. COM-HPC Interface Connector

The COMh-sdID is a COM-HPC® Server module populated with two 400-pin connectors J1 and J2; each
with 4 rows called rows and all rows are named
A to D on the primary connector J1
E to H on the secondary connector J2
Figure 10: COM-HPC Interface Connectors
4.1 Connecting COM-HPC Interface Connector to Carrier
Board
The COM-HPC interface connectors (J1, J2) are inserted into the corresponding connectors on the
carrier board and secured using the mounting points and standoffs. The height of the standoffs
depends on the height of the carrier board's connector.
The module is powered on by connecting to the carrier board using the interface
connector. Before connecting the module's interface connector to the carrier board's
corresponding connector, ensure that the carrier board is switch off and disconnected
www.kontron.com
COMh-sdID User Guide
42/58