Table of Contents
Advertisement
CP3002-RC/CP3002-RA
2.10.9
CompactPCI Bus Interface
The CP3002-RC/CP3002-RA supports a 32-bit/33 MHz or 32-bit/66 MHz PCI interface with
universal V(I/O) signaling voltages (3.3 V and 5 V) and is capable of driving up to four Com-
pactPCI slots with individual arbitration and clock signals.
Warning!
The CP3002-RC/CP3002-RA can be operated only in a 3U CompactPCI back-
plane with maximum five slots and rear I/O support on the system slot. Do not
plug a rear I/O configured board in a backplane without rear I/O support. Fail-
ure to comply with the above will result in damage to your board.
The CP3002-RC/CP3002-RA is not hot-swappable but supports the addition or removal of oth-
er boards whilst in a powered-up state.
2.10.10
CompactPCI Rear I/O Interface
The CP3002-RC/CP3002-RA board provides rear I/O connectivity for peripherals. The
CP3002-RC/CP3002-RA can be operated only in a 3U CompactPCI backplane with maximum
five slots and rear I/O support on the system slot.
The CP3002-RC/CP3002-RA rear I/O interface provides the following interfaces (all signals are
available on J2):
• One COMA port (RS-232 signaling); no buffer on the rear I/O module (RTM) is necessary
• One COMB port (RS-232/RS-422 signaling); no buffer on the rear I/O module is neces-
sary
• Two USB 2.0 port
• One VGA analog port
• Four Gigabit Ethernet ports; magnetics on the rear I/O module are necessary
• Two SATA ports
• Five GPIs and three GPOs (TTL signaling)
• Back-up voltage (3.3 V)
• Geographic addressing (GA[4..0])
Note ...
The pinout of the rear I/O CompactPCI connector on the CP3002-RC/CP3002-
RA is not compatible with that of the CP305, CP307, CP308, CP3002 etc. For
this reason, only rear I/O modules specially designed for the CP3002-RC/
CP3002-RA can be used with the board.
ID 1039-3625, Rev. 1.0
Functional Description
Page 2 - 11
Advertisement
Table of Contents
