Vita 57.1 Fmc Lpc Connector - Xilinx ML605 Hardware User's Manual

Chapter 1: ML605 Evaluation Board

20. VITA 57.1 FMC LPC Connector

The ML605 implements both the High Pin Count (HPC, J64) and Low Pin Count (LPC, J63)
connector options of VITA 57.1.1 FMC specification. This section discusses the FMC LPC
J63 connector.
Note:
from the ML605 board.
The FMC standard calls for two connector densities: a High Pin Count (HPC) and a Low
Pin Count (LPC) implementation. A common 10 x 40 position (400 pin locations) connector
form factor is used for both versions. The HPC version is fully populated with 400 pins
present, and the LPC version is partially populated with 160 pins.
The 10 x 40 rows of a FMC LPC connector provides connectivity for:
•
•
•
•
•
Of the above signal and clock connectivity capability, the ML605 implements the full set:
•
•
•
•
Signaling Speed Ratings:
•
•
Mechanical specifications:
•
•
The Samtec connector system is rated for signaling speeds up to 9 GHz (18 Gb/s) based on
a -3 dB insertion loss point within a two-level signaling environment.
Note:
at 2.5V (non-adjustable). The 2.5V rail cannot be turned off. The ML605 VITA 57.1 FMC interfaces
are compatible with 2.5V mezzanine cards capable of supporting 2.5V VADJ.
66
Send Feedback
The FMC LPC J63 connector is a keyed connector oriented so that a plug-on card faces away
68 single-ended or 34 differential user defined signals
1 MGT
1 MGT clock
2 differential clocks
61 ground, 10 power connections
34 differential user-defined pairs:
• 34 LA pairs
1 MGT
1 MGT clock
2 differential clocks
Single-ended: 9 GHz / 18 Gb/s
Differential
• Optimal Vertical: 9 GHz / 18 Gb/s
• Optimal Horizontal: 16 GHz / 32 Gb/s
• High Density Vertical 7 GHz / 15 Gb/s
Samtec SEAM/SEAF Series
1.27mm x 1.27mm (0.050" x 0.050") pitch
The ML605 board VADJ voltage for the FMC HPC and LPC connectors (J64 and J63) is fixed
www.xilinx.com ML605 Hardware User Guide
UG534 (v1.9) February 26, 2019