NOTICE OF DISCLAIMER: The information disclosed to you hereunder (the “Information”) is provided “AS-IS” with no warranty of any kind, express or implied. Xilinx does not assume any liability arising from your use of the Information. You are responsible for obtaining any rights you may require for your use of this Information.
Page 3
Overview Xilinx ML605 Board Software Requirements ML605 Setup Restoring ML605 CompactFlash Restoring ML605 Platform and P30T BPI Flash References Note: This presentation applies to the ML605...
Page 4
ML605 Restoring Flash Contents Description Description – A CompactFlash image is provided for restoring the ML605 CompactFlash card – The ISE iMPACT tool is used to restore the onboard non-volatile memories with the contents used in the ML605 Getting Started Guide...
Page 5
Xilinx ML605 Board Note: Presentation applies to the ML605...
Page 6
ISE Software Requirements Xilinx ISE 13.4 software Note: Presentation applies to the ML605...
Page 8
Restoring ML605 CompactFlash Use a CompactFlash reader to mount the ML605 CompactFlash as a disk drive Delete all files on this drive Note: Presentation applies to the ML605...
Page 9
Restoring ML605 CompactFlash Unzip the rdf0022.zip file to your CompactFlash drive – Available through http://www.xilinx.com/ml605 Note: Presentation applies to the ML605...
Page 10
XTP056 – ML605 BIST Flash Application for details – CFG1 – IBERT • See XTP046 – ML605 GTX IBERT Design Creation for details – CFG2 – MIG • See XTP047 – ML605 MIG Design Creation for details – CFG3 – MIG •...
Page 11
Restoring ML605 Platform and P30T BPI Flash...
Page 12
Restoring ML605 Platform and P30T BPI Flash Power on the ML605 board Connect a USB Type-A to Mini-B cable to the USB JTAG connector on the ML605 board – Connect this cable to your PC Note: Presentation applies to the ML605...
Page 13
Restoring ML605 Platform and P30T BPI Flash Unzip the rdf0021.zip file to your C:\ drive – Available through http://www.xilinx.com/ml605 Note: Presentation applies to the ML605...
Page 14
Restoring ML605 Platform and P30T BPI Flash Set S2 to 011001 (1 = on, Position 6 → Position 1) – This selects Platform Flash – Mode Switches set to Slave SelectMAP Set S1 to 0XXX (X = Don’t care, Position 4 → Position 1) –...
Page 15
Restoring ML605 Platform and P30T BPI Flash Open an ISE Design Suite Command Prompt Program the Platform Flash cd C:\ml605_restore_flash impact -batch ml605_program_platflash.cmd Note: Takes about 13 minutes...
Page 16
Restoring ML605 Platform and P30T BPI Flash Set S2 to 001010 (1 = on, Position 6 → Position 1) – This selects P30T BPI – Mode Switches set to BPI-Up Set S1 to 0XXX (X = Don’t care, Position 4 → Position 1) –...
Page 17
Restoring ML605 Platform and P30T BPI Flash Program the BPI Flash impact -batch ml605_program_bpi.cmd Note: Takes about 18 minutes...
Page 18
Restoring ML605 Platform and P30T BPI Flash After Restoring the flash, two designs are loaded in Flash – BPI – Built-In Self Test (BIST) • See XTP056 – ML605 BIST Flash Application for details – Platform Flash – PCIe x8 Gen1 Design •...