Integrated Storage Controller Card; Removing The Integrated Storage Controller Card - Dell EMC Storage NX3340 Installation And Service Manual

Figure 49. Installing the network daughter card
Next steps
1 Install the expansion card riser
2 Follow the procedures in

Integrated storage controller card

Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal drives of your system. The controller supports SAS and SATA drives and also enables you
to set up the drives in RAID configurations as supported by the version of the storage controller.

Removing the integrated storage controller card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedures in
3 Remove the air shroud.
Steps
1 Use the Phillips #2 screwdriver to loosen the screws that secure the integrated storage controller cable to the connector on the
system board.
2 Lift the integrated storage controller cable to disconnect it from the connector on the system board.
2, depending on the configuration of your system.
After working inside your system
Safety instructions
Before working inside your system
Installing and removing system components 91