Figure 92. Installing the network daughter card
Next steps
1
Install the expansion card riser 2 or the rear drive cage, depending on the coniguration of your system.
2
Follow the procedure listed in
Related link
Installing expansion card riser 2
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal drives of your system. The controller supports SAS and SATA drives and also enables you
to set up the drives in RAID conigurations as supported by the version of the storage controller.
Removing integrated storage controller card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air shroud.
4
Remove the expansion card riser 1.
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
2
Lift the integrated storage controller cable away from the integrated storage controller.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
139