Table of Contents
Advertisement
2
Follow the procedures in
Initializing the TPM 1.2 for TXT users
1
While booting your system, press F2 to enter System Setup.
2
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3
From the TPM Security option, select On with Pre-boot Measurements.
4
From the TPM Command option, select Activate.
5
Save the settings.
6
Restart your system.
7
Enter System Setup again.
8
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
9
From the Intel TXT option, select On.
Control panel
A control panel allows you to manually control the inputs to the system.
Your system supports:
•
Left control panel: Contains status LEDs, system ID button, and iDRAC Quick Sync 2 (optional).
•
Right control panel: Contains power button, USB 2.0 port, micro USB for iDRAC Direct, and status LED for iDRAC Direct.
Removing the left control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
3
Remove the
air
shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
4
For ease of removal of the left control panel, remove the cooling fan #1 to access the cable latch.
Steps
1
Pull the cable latch, and then disconnect the control panel cable from the system board connector.
2
Use the Phillips #1 screwdriver to remove the screws that secure the cable cover.
After working inside your system
Safety instructions
Before working inside your system
Installing and removing system components
117
- Quick Links:
- Front View of the System
Hide quick links:
Advertisement
Table of Contents
