Installing A Processor And Heat Sink Module - Dell EMC Storage NX3340 Installation And Service Manual

Figure 36. Installing the heat sink onto the processor
Next steps
1 Install the processor and heat sink
2 Install the air shroud.
3 Follow the procedures in

Installing a processor and heat sink module

Prerequisites
CAUTION: Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is necessary to
maintain proper thermal conditions.
1 Follow the safety guidelines listed in
2 If installed, remove the processor blank and CPU dust cover.
Steps
1 Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on the
processor socket.
CAUTION: To avoid damaging the fins on the heat sink, do not press down on the heat sink
fins.
NOTE: Ensure that the PHM is held parallel to the system board to prevent damaging the components.
2 Push the blue retention clips inward to allow the heat sink to drop into place.
3 Support the heat sink with one hand.
4 Use the Torx #T30 screwdriver, tighten the screws on the heat sink in the following order:
module.
After working inside your system
Safety instructions
Installing and removing system components 79