Storage Controller Card; Removing The Integrated Storage Controller Card; Installing An Integrated Storage Controller Card - Dell EMC PowerEdge T140 Service Manual

Storage controller card

Removing the integrated storage controller card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure that is listed in
3 Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
Steps
1 Press the expansion card retention latch and push down the latch to open it.
2 Hold the expansion card by the edge, and pull the card to disconnect from the system board connector.
Figure 32. Removing the integrated storage controller card
3 If you are not replacing the integrated storage controller card, install a filler bracket.
NOTE: Installing the filler bracket for integrated storage controller card is similar to installing the filler bracket under,
removing a PCIe expansion card
Next step
1 Replace the integrated storage controller

Installing an integrated storage controller card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure that is listed in
Safety instructions.
Before working inside your
section.
card.
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 63