Dell EMC Storage NX3340 Installation And Service Manual page 31

Option Description
Option
Number of Cores
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable SATA and PCIe RAID mode on your system.
NOTE: Dell EMC NAS system does not support HDDs connected to SATA ports and does not enable SATA RAID Mode. It
supports only PERC RAID Controller.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click SATA Settings.
SATA Settings details
The SATA Settings screen details are explained as follows:
Option Description
Embedded SATA Enables the embedded SATA option to be set to Off , AHCI, or RAID modes. This option is set to AHCI Mode by
default.
Security Freeze Sends Security Freeze Lock command to the embedded SATA drives during POST. This option is applicable only
Lock for AHCI Mode. This option is set to Enabled by default.
Write Cache Enables or disables the command for the embedded SATA drives during POST. This option is set to Disabled by
default.
Port n Sets the drive type of the selected device.
For AHCI Mode or RAID Mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Description
Specifies the number of cores per processor.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the drive. This field is undefined for removable media
devices such as optical drives.
Pre-operating system management applications 31