Dell EMC Storage NX3340 Installation And Service Manual page 86

2 Follow the procedures in
3 If applicable, disconnect the cables from the expansion card.
NOTE: When removing a card from the riser 1, open the PCIe card holder latch. If applicable, remove the PCIe guide and then
remove the expansion card.
Steps
1 If applicable, lift the expansion card latch(es) out of the slot.
2 Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
Figure 42. Removing an expansion card from riser 1A
Figure 43. Removing an expansion card from riser 2A
3 If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion
card latch.
86 Installing and removing system components
Before working inside your system