Removing An Expansion Card Riser - Dell EMC Storage NX3340 Installation And Service Manual

Card type
FC8 HBA (Emulex)
FC8 HBA (QLogic)
1Gb NICs (Broadcom)
1Gb NICs (Intel)
External RAID (Dell design)
Integrated RAID (Dell design)
rNDC (Broadcom)
rNDC (Intel)
rNDC (Mellanox)
rNDC (QLogic)

Removing an expansion card riser

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedures in
3 Before removing the expansion card riser 2A, remove the expansion card from the riser, if installed.
4 Disconnect any cables connected to the expansion card.
Step
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
Figure 38. Removing the expansion riser 1A
Slot priority
1
1, 2
1, 2
1, 2
1, 2
Integrated Slot
Integrated Slot
Integrated Slot
Integrated Slot
Integrated Slot
Safety instructions
Before working inside your system
Form factor
Low Profile
Low Profile
Low Profile
Low Profile
Low Profile
NONE
NONE
NONE
NONE
NONE
Installing and removing system components 83