Installing The Drive Backplane - Dell EMC Storage NX3340 Installation And Service Manual

Figure 60. Removing drive backplane
Figure 61. 8 X 2.5 drive backplane
1 release tab (2)
3 backplane signal cable connector
5 SAS cable B connector
Next step
Install the drive backplane.

Installing the drive backplane

Prerequisite
Follow the safety guidelines listed in
NOTE: The procedure to install the backplane is similar for all backplane configurations.
Steps
1 Use the hooks on the system as guides to align the slots on the backplane with the guides on the system.
2 Lower the drive backplane until the blue release tabs snap into place.
100 Installing and removing system components
Safety instructions.
2 SAS cable A connector
4 backplane
6 power cable connector