Table of Contents
Advertisement
Follow the procedure listed in
Integrated storage controller card
Removing the integrated storage controller card
Prerequisites
Follow the safety guidelines listed in
Follow the procedure listed in
Remove the air
shroud.
Steps
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system
board.
Lift the integrated storage controller cable to disconnect it from the connector on the system board.
Figure 87. Removing the integrated storage controller cable
Lift one end of the card and angle it to disengage the card from the card holder on the system board.
Lift the card out of the system.
After working inside your
system.
Safety
instructions.
After working inside your
system.
Installing and removing system components
131
Advertisement
Table of Contents
