Removing The Processor From The Processor And Heat Sink Module - Dell EMC Storage NX3340 Installation And Service Manual

c Return to the first screw and loosen it completely.
NOTE: It is normal for the heat sink to slip off the blue retention clips when the screws are partially loosened, continue
to loosen the screws.
2 Push both blue retention clips simultaneously, lift the processor and heat sink module (PHM) out of the system.
3 Set the PHM aside with the processor side facing up.
Figure 31. Removing the processor and heat sink module
Next step
Install the PHM.
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE: Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1 Follow the safety guidelines listed in
2 Follow the procedures in
3 Remove the air shroud.
4 Remove the processor and heat sink
Steps
1 Place the heat sink with the processor side facing up.
2 Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
Safety instructions
Before working inside your system
module.
Installing and removing system components 75