CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2
Use a plastic scribe to pry out the system battery.
Figure 65. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 66. Installing the system battery
Next steps
1
Install the expansion card riser 1A.
2
If applicable, connect the cables to the expansion card(s) in the expansion card riser 1A.
3
Follow the procedures in
4
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5
Enter the correct time and date in the System Setup Time and Date fields.
6
Exit the System Setup.
USB module
An additional USB port can be added to the front of the system. Depending on the configuration of your system, you can add either a USB
3.0 or USB 2.0 module. The USB module cable connects to the internal USB port on the system board.
Removing the USB module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
3
Remove the
backplane
4
Remove the
air
shroud.
104
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
cover.