Installing The System Board - Dell EMC Storage NX3340 Installation And Service Manual

CAUTION:
a Air shroud
b All expansion card risers
c Integrated storage controller card
d Internal USB key (if installed)
e USB 3.0 module(if installed)
f Processors and heat sink modules
CAUTION:
you cover the processor socket with the processor dust cover.
g Memory modules and memory module blanks
h Network daughter card
Steps
1 Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the system board from the chassis.
2 Holding the post, lift the blue release pin, and slide the system board toward the front of the system to disengage the connectors from
the slots on the chassis.
3 Incline the system board at an angle, and lift the system board out of the chassis.
Figure 75. Removing the system board
Next step
Install the system board.

Installing the system board

Prerequisite
Follow the safety guidelines listed in
Do not lift the system board by holding a memory module, processor, or other components.
To prevent damage to the processor socket when replacing a faulty system board, ensure that
Safety instructions.
Installing and removing system components 113