Hard Drives; Removing A Drive Blank - Dell EMC Storage NX3340 Installation And Service Manual

Figure 53. Installing the integrated storage controller card cable
Next steps
1 Install the air shroud.
2 Follow the procedures in

Hard drives

The NX3340 system supports up to four 2.5 inch, hot swappable SAS, SATA hard drives.

Removing a drive blank

Prerequisites
1 Follow the safety guidelines listed in
2 If installed, remove the front bezel.
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION: Mixing drive blanks from previous generations of storage systems is not supported.
Step
Press the release button and slide the drive blank out of the drive slot.
94 Installing and removing system components
After working inside your system
Safety instructions