Optical Drive-Optional; Removing The Optical Drive - Dell EMC Storage NX3340 Installation And Service Manual

2 Follow the procedures in
Steps
1 Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2 If installed, remove the USB memory key from the USB port.
3 Insert the replacement USB memory key into the USB port.
Next steps
1 Follow the procedures in
2 While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optical drive—optional
Optical drives retrieve and store data on optical discs such as CD and DVD. Optical drives can be categorized into two basic types: optical
disc readers and optical disc writers. This system supports SATA DVD-ROM drive or DVD+/-RW drive.

Removing the optical drive

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedures in
3 If applicable remove the
4 Disconnect the power and data cables from the connectors on the optical drive.
NOTE: Ensure that you note the routing of the power and data cable on the side of the system and drive. Route these
cables properly when you replace them to prevent them from being pinched or crimped.
Steps
1 Press the release tab to release the optical drive.
2 Slide the optical drive out of the system until it is out of the optical drive slot.
3 If you are not adding a new optical drive, install the optical drive blank. The procedure to install the optical drive blank is the same as
the optical drive.
Figure 69. Removing the optical drive
Before working inside your system
Optional internal USB memory key
After working inside your system
Safety instructions
Before working inside your system
front bezel.
section.
Installing and removing system components 107