Figure 47. Installing an expansion card into the expansion riser 2A
Next steps
1
After installing a card into the riser 1, close the PCIe card holder latch. If applicable, close the PCIe guide after installing the expansion
card.
2
Follow the procedures in
3
Install any device drivers required for the card as described in the documentation for the card.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the flexibility of selecting different network
connectivity options.
Removing the network daughter card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
3
Remove the
expansion card riser
Steps
1
Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2
Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3
Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
After working inside your system
Safety instructions
Before working inside your system
2, depending on the configuration of your system.
Installing and removing system components
89