Idrac Direct Led Indicator Codes; Idrac Quick Sync 2 Indicator Codes - Dell EMC Storage NX3340 Installation And Service Manual

Power indicator codes

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
iDRAC Direct LED indicator is located below the iDRAC Direct port on the right control panel. You can configure iDRAC Direct using a USB
to micro USB (type AB) cable, which you can connect to your laptop or tablet. The following table describes iDRAC Direct activity when
the iDRAC Direct port is active:
iDRAC Direct LED
indicator code
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two
seconds and off for two
seconds)
Turns off

iDRAC Quick Sync 2 indicator codes

The iDRAC Quick Sync 2 module (optional) is located on the left control panel of your system.
Figure 15. iDRAC Quick Sync 2 indicators
iDRAC Quick Sync 2 indicator
code
Off (default state)
Solid white
Blinks white rapidly
Blinks white slowly
Blinks white five times rapidly and
then turns off
Condition
CAUTION: If two PSUs are used, they must be of the same type and have the same maximum
output power.
Condition
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Condition
Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC Quick
Sync 2 button to turn on the iDRAC Quick
Sync 2 feature.
Indicates that iDRAC Quick Sync 2 is ready
to communicate. Press the iDRAC Quick
Sync 2 button to turn off.
Indicates data transfer activity.
Indicates that firmware update is in
progress.
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Corrective action
If the LED fails to turn on, reseat the left control panel
flex cable and check. If the problem persists, see the
Getting help section.
If the LED fails to turn off, restart the system. If the
problem persists, see the Getting help
If the indicator continues to blink indefinitely, see the
Getting help section.
If the indicator continues to blink indefinitely, see the
Getting help section.
Check if iDRAC Quick Sync 2 feature is configured to
be disabled by iDRAC. If the problem persists, see the
Getting help section. For more information, see
Diagnostics and indicators
section.
49