Installing The Integrated Storage Controller Card - Dell EMC Storage NX3340 Installation And Service Manual

Next step
Install the integrated storage controller

Installing the integrated storage controller card

Prerequisite
Follow the safety guidelines listed in
Steps
1 Angle the integrated storage controller card and align the end of the card with the controller card connector on the system board.
2 Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on the system
board.
NOTE: Ensure that the slots on the system board align with the screw holes on the integrated storage controller card
connector.
Figure 52. Installing the integrated storage controller card
3 Route the integrated storage controller card cable along the wall of the system.
4 Align the screws on the integrated storage controller card cable with the screw holes on the connector.
5 Use the Phillips #2 screwdriver to tighten the screws to secure the integrated storage controller card cable to the card connector on
the system board.
card.
Safety instructions.
Installing and removing system components 93