Removing The Drive From The Drive Carrier - Dell EMC Storage NX3340 Installation And Service Manual

1 Follow the safety guidelines listed in
2 If applicable, remove the drive blank.
Steps
1 Press the release button on the front of the drive carrier to open the release handle.
2 Insert the drive carrier into the drive slot and slide until the drive connects with the backplane.
3 Close the drive carrier release handle to lock the drive in place.
Figure 57. Installing a drive carrier
Next step
If applicable, install the front bezel.

Removing the drive from the drive carrier

Prerequisite
CAUTION: Mixing drives from previous generations of storage systems is not supported.
Steps
1 Using Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
Safety instructions
Installing and removing system components 97