Yamaha MTN1000 2016 Service Manual page 651

No. Item
246 Cruise control
EAS32023
TROUBLESHOOTING DETAILS (EVENT CODE)
Event code No. 30
Event code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 The vehicle has overturned.
2 Installed condition of lean angle
sensor.
3 Defective lean angle sensor.
Symptom
Automatic turning off
of the cruise control
system detected
30
Latch up detected.
Unable to start engine
Unable to drive vehicle
08
Lean angle sensor output voltage
• 0.4–1.4 (upright)
• 3.7–4.4 (overturned)
Remove the lean angle sensor and incline it more than 65 degrees.
Maintenance job
Raise the vehicle upright.
Check the installed direction
and condition of the sensor.
Execute the diagnostic mode.
(Code No. 08)
Replace if defective.
Refer to "CHECKING THE
LEAN ANGLE SENSOR" on
page 8-201.
9-24
EVENT CODE TABLE
Possible causes
The cruise control sys-
tem will automatically
turn off under the follow-
ing conditions:
• Unable to maintain the
set cruising speed
when traveling up a
steep slope
• Wheel slip detected
• Engine stalls
• Sidestand is extended
• Start/engine stop
switch is set to the "
position
Note
The automatic turning off of
the cruise control system
does not indicate a mal-
function in the system.
"
Confirmation of service com-
pletion
Turn the main switch to "ON",
then to "OFF", and then back to
"ON".
Engine trouble warning light
does not come on  Service is
finished.
Engine trouble warning light
comes on  Go to item 2.
Turn the main switch to "ON",
then to "OFF", and then back to
"ON".
Engine trouble warning light
does not come on  Service is
finished.
Engine trouble warning light
comes on  Go to item 3.
Turn the main switch to "ON",
then to "OFF", and then back to
"ON".
Engine trouble warning light
does not come on  Service is
finished.
Engine trouble warning light
comes on  Go to item 4.