Yamaha MTN1000 2016 Service Manual page 248

3. Tighten:
• Lower handlebar holder nuts
Lower handlebar holder nut
40 N·m (4.0 kgf·m, 29 lb·ft)
4. Install:
• Throttle grip "1"
• Throttle cables
• Throttle cable housings "2"
• Grip end
Throttle cable housing bolt
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
Grip end
26 N·m (2.6 kgf·m, 19 lb·ft)
TIP
• Align the projection "a" on the throttle cable
housing with the hole "b" in the handlebar.
• There should be 1–3 mm (0.04–0.12 in) of
clearance "c" between the throttle grip and the
grip end.
1
c
5. Install:
• Handlebar switch (right)
Handlebar switch screw (right)
3.5 N·m (0.35 kgf·m, 2.5 lb·ft)
TIP
Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
a
b
6. Install:
• Front brake master cylinder assembly
2
b
a
2
Refer to "INSTALLING THE FRONT BRAKE
MASTER CYLINDER" on page 4-50.
7. Install:
• Clutch lever holder "1"
• Clutch cable
Clutch lever holder pinch bolt
11 N·m (1.1 kgf·m, 8.0 lb·ft)
TIP
Align the center of slit on the clutch lever holder
with the punch mark "a" on the handlebar.
8. Install:
• Handlebar switch holder
• Handlebar switch (left)
Handlebar switch holder screw
3.5 N·m (0.35 kgf·m, 2.5 lb·ft)
Handlebar switch screw (left)
1.8 N·m (0.18 kgf·m, 1.3 lb·ft)
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
a
9. Install:
• Handlebar grip "1"
• Grip end "2"
Grip end
26 N·m (2.6 kgf·m, 19 lb·ft)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto the
4-77
HANDLEBAR
1
a
b