Yamaha MTN1000 2016 Service Manual page 182

Side cover bolt
1.5 N·m (0.15 kgf·m, 1.1 lb·ft)
2
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS31641
REMOVING THE ECU (Engine Control Unit)
1. Disconnect:
• ECU coupler "1"
TIP
While pushing the portion "a" of the ECU cou-
pler, move the lock lever "b" in the direction of
the arrow shown to disconnect the coupler.
EAS31642
INSTALLING THE ECU (Engine Control Unit)
1. Connect:
• ECU coupler "1"
TIP
Connect the ECU coupler, and then push the
lock lever "a" of the coupler in the direction of the
arrow shown.
1
b
a
1
a
GENERAL CHASSIS (1)
EAS31772
REMOVING THE AIR SCOOP
The following procedure applies to both of the air
scoops.
1. Remove:
• Quick fastener "1"
• Air scoop cap "2"
1
2. Remove:
• Air scoop bolt "1"
• Washer
• Air scoop "2"
TIP
• Remove the projections "a" on the air scoop
from the slots "b" in the fuel tank cover.
• Remove the parts "c" on the air scoop from the
cutouts "d" in the air scoop stay.
• Remove the projection "e" on the air scoop
from the hole "f" in the air scoop stay.
f
d
EAS31773
INSTALLING THE AIR SCOOP
The following procedure applies to both of the air
scoops.
1. Install:
• Air scoop "1"
• Washer
• Air scoop bolt "2"
TIP
• Install the projections "a" on the air scoop into
the slots "b" in the fuel tank cover.
• Install the parts "c" on the air scoop into the cut-
outs "d" in the air scoop stay.
4-11
2
b
b
d
c
e c
a
a
1
2