Yamaha MTN1000 2016 Service Manual page 505

Fault code No.
Item
C-8 Delete the fault code and check
that the engine trouble warning
light goes off.
Fault code No. P0560
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Malfunction in charging system. Check the charging system.
2 Delete the fault code and check
that the engine trouble warning
light goes off.
P0500, P1500
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Turn the main switch to "ON",
and then rotate the rear wheel
by hand.
Start the engine, and input the
vehicle speed signals by operat-
ing the vehicle at 20 to 30 km/h
(12 to 19 mph).
Confirm that the fault code has
a condition of "Recovered"
using the malfunction mode of
the Yamaha diagnostic tool, and
then delete the fault code.
Delete this fault code even if it
has a condition of "Detected".
P0560
Charging voltage is abnormal.
Able to start engine
Able to drive vehicle
—
—
—
Maintenance job
Refer to "CHARGING SYSTEM"
on page 8-13.
Defective rectifier/regulator or
AC magneto  Replace.
Defective connection in the
charging system circuit  Prop-
erly connect or replace the wire
harness.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
8-88
FUEL INJECTION SYSTEM
Confirmation of service com-
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 2 and finish the service.
Condition is "Detected" 
Repeat item 1.
pletion