Yamaha MTN1000 2016 Service Manual page 272

EWA13770
WARNING
Do not attempt to straighten a bent pivot
shaft.
3. Wash:
• Pivot shaft
• Dust covers
• Collar
• Bushing
• Washer
Recommended cleaning solvent
Kerosene
4. Check:
• Dust covers "1"
• Oil seals "2"
Damage/wear  Replace.
• Collar "3"
Damage/scratches  Replace.
• Bearings "4"
Damage/pitting  Replace.
• Bushing "5"
Damage/pitting  Replace.
1
4
2 4
3
4
EAS30228
INSTALLING THE SWINGARM
1. Lubricate:
• Dust covers
• Pivot shaft
• Oil seals
• Collar
• Bushing
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1"
(to the swingarm)
• Oil seals "2"
(to the swingarm)
Installed depth "a"
0–1.0 mm (0–0.04 in)
Installed depth "b"
4.0 mm (0.16 in)
TIP
• When installing the oil seals to the swingarm,
face the character stamp of the oil seals out-
side.
• Press in the oil seal so it does not protrude
from the end surface of the swingarm.
4-101
SWINGARM
5
2
New
4
1