Yamaha MTN1000 2016 Service Manual page 123

1. Air filter case
2. Cylinder head cover
3. Air cut-off valve
4. Air induction system hose (air filter case to air
cut-off valve)
5. Reed valve cover
6. Air induction system hose (air cut-off valve to
reed valve cover)
7. Air cut-off valve
8. Cylinder identification sensor lead
A. Point the end of the clamp to the left. Install
the air induction system hose with its white
paint mark facing outward. Make sure that
the clamp does not go on top of the stopper.
When installing the air induction system
hose, may apply silicone fluid or water to the
air induction system hose.
B. Point the end of the clamp rearward.
C. Point the end of the clamp to the left.
D. Insert the air induction system hose until it
contacts the reed valve cover. Make sure that
the clamp does not go on top of the flange of
the hose.
E. Point the end of the clamp to the right.
2-78
CABLE ROUTING