Yamaha MTN1000 2016 Service Manual page 198

c. If the runout is above specification, remove
the sensor rotor from the wheel, rotate it by
two or three bolt holes, and then install it.
Wheel sensor rotor bolt
8 N·m (0.8 kgf·m, 5.8 lb·ft)
LOCTITE®
ECA17200
NOTICE
Replace the wheel sensor rotor bolts with
new ones.
d. If the runout is still above specification, re-
place the wheel sensor rotor.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30152
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
TIP
Place the front wheel on a suitable balancing
stand.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Spin the front wheel.
b. When the front wheel stops, put an "X
at the bottom of the wheel.
c. Turn the front wheel 90 so that the "X
is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
f. Repeat steps (c) through (e) several times
until all the marks come to rest at the same
spot.
g. The spot where all the marks come to rest is
the front wheel's heavy spot "X".
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Adjust:
• Front wheel static balance
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install a balancing weight "1" onto the rim ex-
actly opposite the heavy spot "X".
TIP
Start with the lightest weight.
4-27
FRONT WHEEL
" mark
1
" mark
1
" mark at
2